Access monitoring and control system "Itrium" server settings features

To connect TRASSIR to Itrium AMCS server you need Client DNO, which can be downloaded at trassir.com. Proceed as follows:

  1. Unzip archive content on PC where Client DNO will be started.

    Client DNO can be started at any PC being in the same local network with TRASSIR and Itrium AMCS servers. We advise to run it at the same PC where AMCS server is installed.

  2. Install "OpenOPC Gateway Service". To do this, run OpenOPC-1.3.1.win32-py2.7.exe from archive.

  3. Start Client DNO with the following parameters: 

    OpcClient.exe 15234 localhost 7766 C:\OpenOPC\bin

    whereas:

    • 15234 - port via which TRASSIR will connect to Client's security and fire alarm system. Same value shall be specified in system connection settings.
    • localhost - IP-address or DNS-name of PC on which "OpenOPC Gateway Service" is running.
    • 7776 - Itrium AMCS server port (set in AMSC).
    • C:\OpenOPC\bin - path to exe files of "OpenOPC Gateway Service" (to be selected during service installation process).

    Important

    Client DNO should be started under that has user administrator rights.

    Any amount of TRASSSIR servers can be connected to a single DNO Client.

After that you can go to TRASSIR to AMCS connection settings.